AC COAT EX 4004 20KG
TOP COATING
If ultra AC Coat EX 4004 30-36.`” is to be top coated with anything other than an alkyd enamel conforming to DOD-E-24607 as specied in
MIL-A-3316C, the user must conform by his own tests that the products are compatible and that the final results are satisfactory.
CLEAN UP
Use clean fresh water for cleaning brushes and equipment before product dries. Dry products may be removed with hot soapy water or strong solvents such as chlorinated solvent (non-flammable) or mineral spirits (flammable).
Call
(AC Duct Canvas Inslation Glue)
MATERIAL PREPARATION DO NOT THIN.
Apply Only to clean, dry, oil-free surfaces. Keep the container closed when not in use.
APPLICATION
1.ApplyatackcoatofultraACCoatEX4004at60—70sq.ft.pergal.(1.5—1.7 m2/I).
2. Immediately imbed the selected lagging fabric into the wet coating. Smooth to avoid wrinkles and overlap seams by at least 2 inches (5 cm).
3. I .Immediately apply a nish coat at 60 — 70 sq. ft. per gal. (1.5— 1.7 m2/1). The dry lm thickness of this application will vary with
the fabric selected. For air conditioning ducts, increase the coverage rate to 40 — 50 sq. ft. per gal. (1.0-1.2 m2/I) for each coat. BRUSH Use clean paint brushes (suitable for water-based paints). Apply with full brush and spread out evenly.
SPRAY
Ultra AC Coat EX 4004may be airless spray applied. For spray equipment information please consult Airless Spray Recommendations or contact your airless spray equipment supplier. Average viscosity range: 55,000-75,000 cps. Corrosion resistant pumps and fittings are suggested
